SDZ-300BS DC output Automatic Commutator Spot Welding Machine
本机是专为电机换向器与较粗电枢绕组连接的一种专用焊接设备。采用进口PLC控制器和触摸屏显示器控制焊机动作，伺服电机力矩控制方式加压，通过同步带轮带动丝杆控制焊接，在单个焊点可分别设定压力，配置大功率米亚基逆变焊机联合控制、可定电流、定功率、定电压等控制、多种焊接规范编号、多段通电方式。具有电流缓升、缓降功能。能通过各段焊接电流的合理选择来达到高质量的焊接，工件机械定位对槽，可设定角度补偿，配有内置冷却水箱，进口电磁阀控制焊接气缸，快速稳定，所有动作一次完成，操作简单，性能优越，焊接质量高。
This machine is designed for motor commutator and thicker armature winding connection of a special welding equipment.Imported PLC controller and touch screen display control welding action, servo motor torque control mode pressure, driven by synchronous pulley screw control welding, in a single solder joint can be set pressure, the configuration of high-power MMA sub-inverter welding Machine control, can be set current, constant power, constant voltage control, a variety of welding code number, multi-section power mode. With the current slow rise, slow down function. Can be selected by the reasonable choice of welding current to achieve high-quality welding, the workpiece mechanical positioning on the slot, can be set to the angle compensation, with built-in cooling water tank, import solenoid valve control welding cylinder, fast and stable, all actions once completed Simple, superior performance, high-quality welding.
技术参数/Technicai Parameters
| 线电压线电压Supply voltage | AC380±10% 50Hz |
| 汽源重压Air pressure | 0.5~0.7MPa |
| 变频器Rectifier(自选Optional) | IPB-5000 / IS-300A |
| 短路电流Short Circuit Current | 5000A / 10000A |
|
可焊线径Wire diameter |
Φ0.12~0.5mm/Φ0.5~1.2mm |
| 转子直径Rotor Diameter | ≤Φ90mm |
| 轴径Shaft diameter | ≤Φ17mm |
| 换向器直径Commutator diameter | ≤Φ40mm |
